|
Post by Shooting on Jun 27, 2013 21:19:38 GMT
HOW ITS DONE! ============= A radio can be decoded by 2 methods, firstly by its Serial Number and secondly by its Dump. (Software on a chip inside the Radio) Not all radios can be decoded via the serial number so the best method is reading its chip. You can do this by unsoldering the radios chip and reading it in an eeprom reader on your PC then post its contents here for your code. Tho tricky its easier than you think. ---------------------------------------------------------------------- The tools needed to get you dump are: 1. Soldering iron 2. Solder 3. Programmer (Depending on the chip) 4. Knowledge of the chip to read In some cases you can use a Hot Air Station instead of a Soldering iron ---------------------------------------------------------------------- Here are some pics of some tools that I have...
|
|
|
Post by Shooting on Jul 3, 2013 13:36:08 GMT
|
|
|
Post by Shooting on Jul 3, 2013 13:40:40 GMT
|
|
|
Post by Shooting on Jul 3, 2013 13:42:20 GMT
MCU reader on a breadboard ========================== Motorola Cracker 6.2 Download at the bottom of this post. Password given Via PM MC68HC05 ======== RXD: 61 - Prog. TXD TXD: 62 - Prog. RXD RST: 58 - Prog. RST MODB: 59 - GND MODA: 60 - GND GND: 37,67 - GND VDD: 01,68 Just connect TXD, RXD, Reset, GND, VDD. MOD A, MOD B to ground ---------------- 68HC11L6 - PLCC68 ================= RxD 26 pin TxD 28 pin RST 23 pin MOD 2 pin ------------------ Attachments:
Motorola-Cracker-6-2.zip (248.96 KB)
|
|